This control can be mounted starboard or port side and is stackable. Offers "push to choke" ignition switch, 8 pin connector wiring harness, lanyard stop switch, separate neutral warm‑up lever and requires Gen I throttle and shift cables. 5 pin accessory plug for tachometer and an adjustable throttle friction. Not for use with engines that have counter rotating lower units. Older engines may require an adapter harness.
This control features a non ‑ powered trim handle with a 15 ft.(4.58 m) harness. Does not have a warning horn and features push throttle cable operation.
Fits Mercury/Mariner Outboards 20/25 HP U.S. serial numbers 0G044026 and below; Belgium serial numbers 9807908 and below.
GEN I cables must be used.
This control can be mounted starboard or port side and is stackable. Offers "push to choke" ignition switch, 8 pin connector wiring harness, lanyard stop switch, separate neutral warm‑up lever and requires Gen I throttle and shift cables. 5 pin accessory plug for tachometer and an adjustable throttle friction. Not for use with engines that have counter rotating lower units. Older engines may require an adapter harness.
This control features a non ‑ powered trim handle with a 15 ft.(4.58 m) harness. Does not have a warning horn and features push throttle cable operation.
Fits Mercury/Mariner Outboards 20/25 HP U.S. serial numbers 0G044026 and below; Belgium serial numbers 9807908 and below.
GEN I cables must be used.