Throttle and Shift Cables

OEM Throttle and Shift Cables for your Mercury/Mercruiser, Mercury Outboard or SportJet Mechanical Control

Gen I (1), Gen II (2) or SAE throttle and shift cables from Quicksilver & Mercury Marine are all here. 

Most of the throttle and shift cables here are the Quicksilver Platinum Plus series. these are built for a long life and designed for maximum performance in all weather conditions – even down to 0 degrees Fahrenheit.

These cables feature layered technology with 
‑ Tough polypropylene outer jacket is UV and abrasion resistant
‑ 22 oil‑tempered wires for increased compression strength and durability
‑ Lubricated core liner to stand up to the harsh marine environment while remaining flexible
‑ Patented hexagonal shape allows for minimal contact with the liner
‑ Stainless steel core is specially designed to handle tough compression loads, but flexible for severe applications

When to replace a cable:

• When there is excessive play or stiffness felt at the control
• Broken, chafed, bent or loose parts

Cables cannot be repaired - they need to be replaced.

Ensure you are ordering the proper length as sharp bends or too-short of cable will result in kinks. Cables that are too long will require unnecessary bends or loops. Both conditions place extra stress on the cables, reducing the life and operation of your cables.

Measure existing cables from tip to tip and subtract 7 inches for length needed to order. 

When measuring cables for console mount control measure along the actual selected cable routing path and add 18 inches (457 mm) to total.
Divide by 12 inches (304 mm). This is the length of the throttle/shift cable you'll need to order. 

2 cables required per control.