Mercury 25-60 HP EFI Outboard Maintenance Schedule & Parts

Follow Mercury Marine factory service intervals to maintain performance, protect engine warranty coverage, and prevent cooling or lower unit failure. Use the interval checklist below to verify required service items, then find exact OEM part numbers and fluid capacities in the reference chart underneath.

Annually or Every 100 Hours

  • Engine Oil & Filter: Drain crankcase oil and install a new OEM oil filter.
  • Gearcase Lubricant: Drain and refill lower unit gear lube; inspect drain plug magnet for metal contamination.
  • Fuel Filtration: Replace primary low-pressure fuel filter elements.
  • Fuel System Treatment: Add Quickleen Engine Treatment to the fuel tank once per year to prevent carbon buildup on injectors and spark plugs.
  • Corrosion Control Anodes: Inspect gearcase and transom bracket anodes; replace if degraded beyond 50%.
  • Lubrication: Grease engine pivot points, swivel brackets, and propeller shaft splines.

Every 3 Years or 300 Hours

  • Complete Annual Service: Perform all standard 100-hour fluid and filter changes.
  • Water Pump Impeller: Replace the water pump impeller or complete pump housing kit.
  • Spark Plugs: Remove and replace spark plugs with factory-gapped OEM plugs.
  • High-Pressure Fuel Filtration: Replace the high-pressure fuel filter element (included in 300-hour kits).
  • Thermostat & Belt: Inspect or replace the engine thermostat and check accessory drive belt condition.

Below is a chart of Mercury outboard maintenance parts including service kits, oil, and anodes for 25, 30, 40, 50 & 60 HP EFI Mercury outboard motors. Click on the part number to order and see current stock status and discounted pricing.

Keeping your new Mercury outboard properly maintained will save you hundreds if not thousands in the long run!

MERCURY OUTBOARD MAINTENANCE PARTS 25-60 EFI
Outboard Type EFI EFI EFI
Outboard Horsepower 25/30 40/50/60 HP
Command Thrust
40/50/60 HP
Standard Gearcase
Outboard Engine Serial 0R106999 & above 1C453840 & above 1C453840 & above
Available Shaft Length (inches) 15, 20 20, 25 20
Engine Oil 10W-30 25W-40 25W-40
Capacity 1.9 qts 3.0 qts. 3.0 qts.
Quart Part # 8M0142141 8M0078629 8M0078629
100 HR Maintenance Kit N/A 8M0090558 8M0090558
300 HR Maintenance Kit 8M0120839 8M0090559 8M0113483
Oil Change Kit 8M0081915 8M0081916 8M0081916
Oil Filter 8M0162831 8M0162829 8M0162829
Low Pressure Fuel Filter 8M0088825 879884T 879884T
Thermostat 8M0119207 8M0168892 8M0168892
Spark Plug 8M0204682 883323001 883323001
Replacement Drive Belt N/A N/A N/A
Gearcase Oil Premium Gear Lube High Performance Gear Lube Premium Gear Lube
Capacity 11.8 oz. 24 oz. 11.5 oz.
Oil Part Number 858058K01 858064K01 858058K01
Impeller 8M0214912 43026T2 19453T
Impeller Kit 8M0208905 8M0100527 812966A12
Anodes
Aluminum Anodes
Trim Tab Anode 853762 N/A N/A
Square Anode 804043 N/A N/A
Power Trim Anode 823912002 818298T1 818298T1
Side Pocket N/A 826134T 826134T
Magnesium Anodes
Power Trim Anode N/A 818298T3 818298T3
Side Pocket N/A 826134T3 826134T3
Anode Kit N/A N/A 8M0107547

Note: Aluminum anodes are for salt or freshwater. Magnesium is for freshwater only.

Important Service Notice: Maintenance intervals, part numbers, and torque specifications frequently change across production runs. Always obtain and consult the official Mercury Marine factory service manual specifically for your outboard’s serial number before performing maintenance or ordering components.